Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateGenie Garage Door Parts in North Las Vegas: What to Know First
We supply and install Genie garage door parts in North Las Vegas, from screw-drive opener gears and carriage assemblies to torsion springs, cables, rollers, and bottom seals. Most Genie repair calls get handled the same day, and we quote the price before the visit so the number on the invoice is the number you agreed to. We’re an independent Genie service provider, which means we work on your door honestly and recommend the right part rather than the most expensive one.
This page is for the Genie owner whose door has started to grind, hesitate, or stay shut. A live person answers the phone at (866) 347-9495 around the clock, quotes the job on that call, and holds the price at the door.
How Genie Products Fail – and How We Fix Them
Genie builds a good product. The failures we see in North Las Vegas homes cluster around a few known weak points, and knowing them saves you from paying for the wrong repair.
- Chain-drive and screw-drive opener gears wear out before the motor does. On Genie ChainMax and older 500-series units, the plastic drive gear inside the housing strips long before the motor quits. Owners hear a hum and see nothing move. The fix is usually a gear-and-sprocket kit, not a whole new opener, and that keeps your price in the low end of our opener repair range.
- The wall console and safety sensors lose their signal in our heat. North Las Vegas summers push garage interior temps well past 110°F, and the thin wire runs Genie uses on safety beams and wall consoles can crack or pull loose at the staples. A door that reverses for no reason is often a sensor alignment or wiring fault, not a bad logic board. We test the beams before we sell you electronics.
- Torsion and extension springs fail on schedule, not by brand. Genie’s extension spring setups on older residential doors are the ones we replace most, because a dry climate speeds up fatigue on the cable ends. Respect this part: a door is 200 pounds riding on two springs, and a loaded spring can injure you badly. We count spring cycles the way you count tire miles and tell you what’s left on yours.
- Cables and drums corrode at the drum flange. Genie drums on doors that sit through dusty desert wind collect grit in the cable groove, which frays the cable from the inside. You won’t see it until it pops. We inspect the drum and cable together, because replacing one without the other is how a door comes back down in a week.
- Nylon rollers and hinges dry out and get noisy. The Genie roller sets on doors a few years old start to rumble because the nylon dries and flattens in the heat. Roller and hinge replacement is one of the cheaper jobs we do, and it quiets a door more than people expect.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Our Genie Garage Door Parts Process
Every Genie job follows the same path, and you’ll know where you are at each step.
- 1
The call. A live person answers, you describe the symptom, and we quote the likely range on that call. We ask the model and serial if you can read it off the opener housing, because it tells us which Genie line we’re dealing with before we load a single part.
- 2
Diagnosis on site. We test the opener, the springs, the cables, the drums, the rollers, and the track before we touch anything. If the opener is straining, the problem is almost never the opener, and we’ll tell you that straight.
- 3
The parts decision. We explain OEM versus quality aftermarket, what each costs, and what each does for your warranty. On Genie units still under a manufacturer warranty, we protect that coverage by matching the part to spec. On older units, a good aftermarket gear kit or spring often makes more sense than an OEM part that costs double.
- 4
The repair. Springs, cables, and drums are handled by trained hands only. We never walk a homeowner through a loaded spring, and we won’t sell you a part you have no safe way to install.
- 5
The test. We cycle the door, check the balance, test the safety reverse, and adjust the travel so it stops where it should. A Genie that reverses on a child’s toy is a Genie that needs its force limits set right.
- 6
The cleanup and the promise. We haul off the old parts, sweep the slab, and hand you a written 90-Day Done Right Promise. If it’s not done right, one call brings us back to make it right.
See the difference
Before
After
Before
After
Before
AfterWhat Genie Garage Door Parts Costs in North Las Vegas
These are the ranges we quote for Genie work in North Las Vegas. The price is quoted and agreed before any work starts, and it doesn’t change between the phone and the driveway.
| Job | Typical Range |
|---|---|
| Genie opener repair (gear kit, sensors, logic) | $120 – $320 |
| Spring repair (torsion or extension) | $180 – $340 |
| Cable and drum repair | $130 – $250 |
| Roller and hinge replacement | $110 – $220 |
| Track realignment | $120 – $240 |
| Panel replacement | $250 – $500 |
| Full garage door repair | $150 – $600 |
| New Genie opener installation | $250 – $550 |
| New door installation | $700 – $2,200 |
What moves the price: door weight, how many springs the door carries, whether the opener is a screw-drive or chain-drive, and whether we’re matching an OEM part for warranty. A single safety-sensor wire fix sits at the bottom of the opener range; a stripped gear kit plus a spring runs toward the top. Estimates are free, and if you have a written estimate from someone else, our second opinion is free too.
Why North Las Vegas Homeowners Call Otto’s Garage Door North Las Vegas for Genie Work
We’re locally owned and owner-operated, with a published address and license number you can verify before we ever pull into your drive. That matters when a national outfit quoted you one price on the phone and billed another at the door. Our technicians have up to 22 years of experience and are trained across Genie plus the other major brands, including LiftMaster and Chamberlain, so a Genie call doesn’t get handed to someone guessing.
Calls are answered by a live person 24/7, including nine at night when a spring lets go and your vehicle is sealed inside. We offer $40 off any repair over $200, no trip charge inside our county, and a permanent 10% discount for seniors and veterans. Every job carries the 90-Day Done Right Promise in writing. When your door is Genie, you want someone who already knows the model. Call (866) 347-9495 for a free estimate.
FAQs
Often yes, and we check before recommending parts. Genie’s warranty terms depend on model and age, so we read your serial plate and match the replacement part to spec when coverage is still active, which keeps your warranty intact. Call (866) 347-9495 for a free estimate and we’ll sort out what you’re covered for.
Most common Genie parts, including gear kits, safety sensors, rollers, and springs, are on hand or sourced the same day for standard repairs. Rarer model-specific parts may take a day or two to order, and we tell you up front which it is so you’re not waiting blind. Call (866) 347-9495 and we’ll tell you what your model needs.
Repair is usually the smarter call when the motor and logic board are healthy and the problem is a gear, sensor, spring, or cable. Replace the opener when the motor itself is failing or the unit is well past its service life and parts get scarce. We’ll give you both numbers and let you decide. Free estimates, no pressure.
A door that reverses by itself is nearly always a safety-sensor or force-limit issue, not a dead opener. The safety beams may be misaligned, or the force limits drifted with the heat and the door is hitting resistance it doesn’t expect. We test the sensors and reset the limits on site. Call (866) 347-9495 to get it checked.
The local pro we connect you with is licensed and insured as the state requires, and you can verify the license number we publish before we arrive. Our technicians have up to 22 years of experience and carry the 90-Day Done Right Promise in writing. Call (866) 347-9495 for a free estimate.
Questions about Genie garage door parts in North Las Vegas? Call Otto’s Garage Door North Las Vegas at (866) 347-9495 for a free estimate. A live person answers, quotes the job on the call, and holds that price when we get there.
Written by the team at Otto’s Garage Door North Las Vegas, serving North Las Vegas and nearby areas.